Specification:
Output
DC Voltage 12.1~12.5V
Light Load Setting /
Current Range 0~120A
Rated Power(2) 1600W
Ripple & Noise (3) <200mV
Output Voltage Accuracy ±2%(Output @ SPS Board )
Setup Time ≤3S (220Vac Input, Full load)
Hold Up Time ≥10mS(230Vac Input, Full load)
Output Inrush <5%
Dynamic 25%-75%Load:10%Vp-p
Input
Voltage Range 185~264Vac
AC Voltage/Frequency Range 200Vac~240Vac/ 47Hz~63Hz
Start-up Voltage 185Vac
Efficiency (Typ.) 91.5%(Intput @ SPS Board)
AC Current(Max) <10A@220Vac
Start-up Inrush Current <40A@230Vac Cold start
Protection
Under voltage Protection Point ≤180Vac Automatic recovery
Under voltage Recovery Point ≤185Vac Automatic recovery
Over Power 1680W~1980W,Automatic recovery
Over Current 140A~165A,Automatic recovery
Short Protection Automatic recovery
Over Temperature Shut down o/p voltage, recovers automatically after temperature goes down
Environment
Working TEMP/Humidity -40℃~50℃; 20%~90%RH Non-condensing
Store TEMP/Humidity -40℃~85℃; 10%~95%RH Non-condensing
Vibration 10 ~ 500Hz, 2G 10min./1cycle, 60min. each along X,Y, Z axes
Shock 20G/11mS pulse ,3 times at each X,Y,Z axes
Altitude 5000m
Safety & EMC
Safety Standards GB4943/EN60950 n reference □certification
Leakage current P-S≤0.25mA P - FG≤3.5mA
With Stand Voltage I/P- O/P:3KVac/10mA I/P-FG:1.5KVac/10mA Test time 1min
Isolated Resistance I/P- O/P: 100M ohms I/P-FG: 100M ohms
Harmonic current EN61000-3-2,-3
EMI EN55022
EMS EN61000-4-2,3,4,5,6,8,11 Class A equipment
Others
Dimension Single:255*91*46mm(L*W*H) / 1.7kg Packaging(10PCS):623*451*266mm / 20kg
Connection Terminal Input: Plug with 3 Chip; output:10pcs 2*XP4.2*6P with 360mm Connection Wire;
Cooling mode Forced air cooling
Reliability
Design MTBF 200,000Hrs AT 25℃, MIL-217 Method 2 Components Stress Method
Design life 2 years@ 40℃ FULL Load and Units Continuously Working
Note
1: All parameters are measured at 230Vac input,rated load and 25℃ of ambient temperature after 15min
working, if not specially mentioned.
2:. Please refer to the reduction curve, location diagram and installation method in detail.
3: Ripple & Noise are measured at 20MHz of bandwidth by using a 12’’ twisted pair-wire terminated with
0.1uF and 10uF parallel capacitor.
4: Please refer to the detailed reduction Curve、Dimension and Mechanical
Reduction curve: